[. . . ] Always check if the water is not too hot, to prevent your hands from getting burnt. -- Warning: Remove the detachable cord from the handheld part before cleaning this part in water. -- Water may leak from the socket at the bottom of the shaver when you rinse it. [. . . ] Using the shaver Note:You can also use the shaver directly from the mains. -- Your skin may need 2 or 3 weeks to get accustomed to the Philips shaving system. 4 Clean the shaver (see chapter ‘Cleaning and maintenance’). Trimming (PT880, PT860 only) You can use the trimmer to groom your sideburns and moustache. 1 Press the on/off button once to switch on the shaver. English 11 2 Push the trimmer slide downwards to open the trimmer. 3 After trimming, close the trimmer and switch off the shaver. Cleaning and maintenance Warning: Remove the detachable cord from the handheld part before cleaning this part in water. Never use compressed air, scouring pads, abrasive cleaning agents or aggressive liquids such as petrol or acetone to clean the appliance. -- Clean the shaver after every shave for optimal shaving performance. -- For the best cleaning results, we advise you to use the Philips Cleaning spray (HQ110). Always check if the water is not too hot, to prevent your hands from getting burnt. Note:Water may leak from the socket at the bottom of the shaver when you rinse it. This is normal and not dangerous because all electronics are enclosed in a sealed power unit inside the shaver. 12 English Cleaning the shaving unit under the tap 1 Switch off the shaver and disconnect it from the mains. 3 Rinse the shaving unit and hair chamber under a hot tap for 30 seconds. Always check if the water is not too hot, to prevent your hands from getting burnt. Be careful not to hit the shaving unit against anything while shaking off excess water. Never dry the shaving unit and the hair chamber with a towel or tissue, as this may damage the shaving heads and the coupling spindles. 5 Open the shaving unit again and leave it open to let the shaver dry completely. Cleaning the shaving unit with the cleaning brush 1 Switch off the shaver and disconnect it from the mains. English 13 2 Press the release button to open the shaving unit. 3 Pull the shaving unit off the shaver. 2 1 4 Turn the lock anticlockwise (1) and remove the retaining frame (2). 5 Remove and clean one shaving head at a time. Note: Do not clean more than one cutter and guard at a time, since they are all matching sets. [. . . ] The staff of this centre will remove the battery for you and will dispose of it in an environmentally safe way. Removing the rechargeable shaver battery Only remove the rechargeable battery when you discard the shaver. Make sure the rechargeable battery is completely empty when you remove it. [. . . ]